Thread: RaLink - rt3562sta module loaded, rt2860 driver in use!

i have referred several methods of installing ralink driver source code.

rt3562sta driver installed:

code:

root@ubuntu-laptop:~# find /lib -name 'rt35*.ko' /lib/modules/3.0.0-13-lowlatency/kernel/drivers/net/wireless/rt3562sta.ko /lib/modules/3.0.0-13-lowlatency/kernel/drivers/staging/rt3562sta.ko

but kernel seems still "using" wrong driver rt2860:

code:

root@ubuntu-laptop:~# lspci -vv ... lines removed ....  24:00.0 network controller: ralink device 3592     subsystem: hewlett-packard company device 1638     control: i/o+ mem+ busmaster+ speccycle- memwinv- vgasnoop- parerr- stepping- serr- fastb2b- disintx-     status: cap+ 66mhz- udf- fastb2b- parerr- devsel=fast >tabort- <tabort- <mabort- >serr- <perr- intx-     latency: 0, cache line size: 64 bytes     interrupt: pin routed irq 19     region 0: memory @ d4600000 (32-bit, non-prefetchable) [size=64k]     capabilities: [40] power management version 3         flags: pmeclk- dsi- d1- d2- auxcurrent=375ma pme(d0-,d1-,d2-,d3hot-,d3cold-)         status: d0 pme-enable- dsel=0 dscale=0 pme-     capabilities: [50] message signalled interrupts: mask- 64bit+ queue=0/5 enable-         address: 0000000000000000  data: 0000     capabilities: [70] express (v2) endpoint, msi 00         devcap:    maxpayload 128 bytes, phantfunc 0, latency l0s <512ns, l1 unlimited             exttag- attnbtn- attnind- pwrind- rbe+ flreset-         devctl:    report errors: correctable- non-fatal- fatal- unsupported-             rlxdord+ exttag- phantfunc- auxpwr- nosnoop-             maxpayload 128 bytes, maxreadreq 512 bytes         devsta:    correrr- uncorrerr- fatalerr- unsuppreq- auxpwr- transpend-         lnkcap:    port #0, speed 2.5gt/s, width x1, aspm l0s l1, latency l0 <512ns, l1 <64us             clockpm+ suprise- llactrep- bwnot-         lnkctl:    aspm disabled; rcb 64 bytes disabled- retrain- commclk+             extsynch- clockpm- autwiddis- bwint- autbwint-         lnksta:    speed 2.5gt/s, width x1, trerr- train- slotclk+ dlactive- bwmgmt- abwmgmt-     capabilities: [100] advanced error reporting <?>     capabilities: [140] device serial number 68-a3-c4-a6-a7-4d-00-00     kernel driver in use: rt2860     kernel modules: rt3562sta

however wlan0 not up, , cannot come up

code:

root@ubuntu-laptop:~# ifconfig eth0      link encap:ethernet  hwaddr 2c:41:38:01:21:54             broadcast multicast  mtu:1500  metric:1           rx packets:0 errors:0 dropped:0 overruns:0 frame:0           tx packets:0 errors:0 dropped:0 overruns:0 carrier:0           collisions:0 txqueuelen:1000            rx bytes:0 (0.0 b)  tx bytes:0 (0.0 b)           interrupt:47 base address:0x6000   lo        link encap:local loopback             inet addr:127.0.0.1  mask:255.0.0.0           inet6 addr: ::1/128 scope:host           loopback running  mtu:16436  metric:1           rx packets:80 errors:0 dropped:0 overruns:0 frame:0           tx packets:80 errors:0 dropped:0 overruns:0 carrier:0           collisions:0 txqueuelen:0            rx bytes:6080 (6.0 kb)  tx bytes:6080 (6.0 kb)   root@ubuntu-laptop:~# ifconfig wlan0 wlan0: error while getting interface flags: no such device

any ideas on how make kernel use loaded rt3562sta module??????

Forum The Ubuntu Forum Community Ubuntu Official Flavours Support Networking & Wireless [ubuntu] RaLink - rt3562sta module loaded, rt2860 driver in use!

Ubuntu